Cadence Q DRIVE SERIES Installationsanleitung Seite 1

18 19The Dakota and Olympia are 1 ohm stable mono block ampliers. They feature RCA pre amp line outputs for feeding of a full range signal to a secon

20 21The Dakota or Olympia can be bridged together for double the power output into a 2-ohm load. Though each amp is 1 ohm stable, when bridging ampli

22 23Once again, when bridging two ampliers together, the nal impedance load of the bridged ampliers should be no lower than 2-ohms. Double power w

24 25Olympia• Rated Power: 2000 Watts RMS @ 1 ohm• Rated Power: 1000 Watts RMS @ 2 ohm• Rated Power: 500 Watts RMS @ 4 ohm• Bridged Power: 4000 Wa

26 272 OHMTO AMPLIFIER4 + 4OHM4 + 4OHM4 + 4OHM4 + 4OHM4 X DUAL VC 8 OHM SPEAKERS WITH SERIES VOICE COILS, ALL IN PARALLEL2 X DUAL VC 2 OHM SPEAKERS WI

Due to constant product improvements, these specifications are subject to change without notice.Though we tried our best to insure that this manual is

INTRODUCTION2FEATURES332Thank you for purchasing this Cadence United Series amplier. Over the years, the technology used to create a

5“ARVA” - AUTOMATIC RAIL VOLTAGE ADJUSTMENT CIRCUITRY:Cadence United Series amplifiers feature “ARVA” circuitry in their power supply. This circuit

6 7ADJUSTING THE SYSTEM Once the system is operational, the rst thing to do, is set all crossover points to approximate settings. In the c

4 Channel Amp with 2 Channel Input8 9If your head unit has only one pair of Left and Right RCA out put jacks, plug them in to RCA input Jacks 1 and 2

10 11Install any combination of speakers independently on all 4 channels being careful not to load any single channel below 2 ohm stereo. For typical

12 13Channels 1 and 2 should be wired to speakers no lower than 2 ohm loads per channel in stereo. Channel 3 and 4 should be bridged as per the diagra

14 15If your head unit has one single pair of RCA outputs, input them in to the ampliers Channel 1 and 2 input jacks and set the Input Mod

16 17Minimum impedance for channels 1 through 4 is 2 ohm stereo. Channel ve minimum impedance is 2 ohm mono capable.Phoenix is a 2 ohm mono block amp