Cadence Flash F100-5 Installationsanleitung PDF herunterladen (Seite 11)

2 CHANNEL AMP BRIDGED MONO

When bridging Cadence two channel

ampliers, the lowest impedance for the

bridged channel is 4 ohms. Set the crossover

switch to Low Pass and Crossover Frequency

Setting to 100 Hz as a beginning point for

tuning your system. Dial in as much Bass

Drive as necessary keeping in mind that

too much Bass Drive can add unnecessary

distortion to your system.

Utilize the Remote Subwoofer Level control

for bass control from the comfort of your

vehicles interior. You must use the cable

that was supplied with the amplier for the

remote control. Use of standard phone cables

can short out the amplier.

If you misplace your cable, please contact us

at 800.477.2328 to procure a replacement or

contact your local Cadence dealer.

SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

REMOTE SUBWOOFER

LEVEL CONTROL

CROSSOVER MODE SWITCH IN

LOW PA SS POSITION

CROSSOVER SWITCH SETTING

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Keine Kommentare

Cadence Flash F100-5 Installationsanleitung Seite 11